Husqvarna HUV 4214 - Manual (Page 37)

Engine Oil
The brake fluid reservoir (5) is located under the hood and under the round access panel (Figure 13). Raise the hood
and remove the round access panel to check the brake fluid level.
During the brake fluid level inspection, also inspect the following:
• The presence of brake fluid on the exterior surface of the master cylinder indicates a leak.
• The brake fluid reservoir diaphragm (located in the cap) should not have holes or other damage.
BRAKE FLUID
Brake fluid level should be within 1/4-inch (6 mm) from the top of the reservoir (Figure 14). Also, brake fluid should be
clean with no residue in the bottom of the reservoir or other evidence of contamination.
CAUTION
• Use only DOT 5 (silicone) brake fluid. Use of any other type brake fluid is not recommended.
ENGINE OIL
Even though the low oil pressure warning light on the instrument panel should illuminate if the oil level becomes low,
the engine oil level should be checked daily. The vehicle should be on a level surface when the oil is checked.
Do not overfill the engine with oil.
ENGINE OIL LEVEL CHECK
1. Remove the oil level dipstick from the oil filler tube and wipe oil from the dipstick (Figure 15). See following
CAUTION.
CAUTION
• Do not remove dipstick while engine is running.
2. Check oil level by fully inserting the dipstick into the tube and immediately removing it.
3. If the oil level is at or below the low level mark on the dipstick gauge, add oil to the engine until the level is
between low and full levels (safe level). See following CAUTION.
CAUTION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or result in
damage to the engine.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 35