Honeywell Eclipse MS5100 Series - Manual (Page 31)

27
D
EFAULT
S
ETTINGS
Many functions of the scanner can be configured or enabled/disabled.
The scanner is shipped from the factory configured to a set of default conditions.
All default parameters of the scanner have an asterisk ( * ) marked in the default
column. If an asterisk is not in the default column then the default setting is off or
disabled. Every interface does not support every parameter. A check
mark ( ) will appear in the interface column if the interface supports the
parameter listed.
Parameter Default RS232
Light
Pen
RS485 S KBW USB
Laser
Emulation
Normal Scan Mode *
Continuous Scan Mode
Blinky Scan
Continuous Blinky Scan
Custom (One Shot) Scan
Manual Activation Mode
CodeGate Active *
CodeGate Inactive
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 Check on ITF
Code 11
Code 39 *
Full ASCII Code 39
Mod 43 Check on Code 39
MSI-Plessy 10/10
Check Digit
MSI-Plessy Mod 10
Check Digit
*
Paraf Support ITF
S Applicable for IBM ® Host applications.