Heat & Glo Fireplace WS-250 - Manual

1
Installers Guide
396-980D 7/00
Please contact your Heat-N-Glo dealer with any
questions or concerns. For the number of your
nearest Heat-N-Glo dealer, please call 952-985-6000.
Printed in U.S.A. Copyright 2000,
Heat-N-Glo, a division of Hearth Technologies Inc.
20802 Kensington Blvd., Lakeville, MN 55044
Models:
WS-150
WS-250
1. When installing your stove, particular attention
should be paid to fire protection. If this unit is not
properly installed, a house fire may result. For
your safety, follow the installation instructions and
contact local building or fire officials about restric-
tions and installation inspection requirements in
your area.
2. Never use gasoline or similar liquids to start a fire
in this unit. Keep all such liquids well away from
stove.
3. During operation, if any part of the stove starts to
glow, the stove is in an overfired condition. Close
the air controls completely until the glowing has
stopped. OVERFIRING VOIDS WARRANTY.
4. Cool ashes should be disposed of carefully, using
a metal container.
5. Do not burn wet or green wood. Store wood in dry
location.
6. Do not burn garbage, treated wood, or wood with
salt (driftwood, etc.). Burning materials other than
wood (including charcoal) under adverse conditions
may generate carbon monoxide in the home, re-
sulting in illness or possible death.
7. Do not permit creosote or soot to accumulate ex-
cessively in the chimney or inside the firebox.
8. Check your chimney system thoroughly when install-
ing into an existing metal or masonry chimney. Seek
professional advice if in doubt about its condition.
9. Do not connect this unit to a chimney flue already
serving another appliance.
10. Comply with all minimum clearances to combustibles
as shown in this manual for this appliance.
11. Build fire on brick firebox floor. Do not use grates,
andirons or other methods to support fuel.
12. HOT WHILE IN OPERATION. Keep children, pets,
clothing and furniture away. Contact can cause skin
burns.
13. Do not connect to any air distribution duct or system.
14. RISK OF FIRE! Do not operate with stove door open.
15. For further information refer to NFPA 211 (U.S.) or
CAN/CSA-B365 (Canada).
16. WARNING: WHEN ASSEMBLING APPLIANCE, USE
ONLY HEAT-N-GLO PRODUCTS MANUFACTURED
COMPONENTS. USE OF ANY OTHER COMPO-
NENTS WILL VOID YOUR WARRANTY AND COULD
PRESENT A SERIOUS SAFETY HAZARD.
17. WARNING: DO NOT OPERATE YOUR WS-150 or
WS-250 STOVE BEFORE FULLY ASSEMBLING ALL
COMPONENTS.
- PLEASE READ ALL OF THE OWNERS MANUAL AND SAFETY NOTES -
IMPORTANT SAFETY NOTES:
This manual contains instructions for:
• Installation • Operation • Maintenance