Before operation checks, Is your engine ready to go, Operation – HONDA GXH50 User Manual
Page 3: Safe operating precautions, Starting the engine, Safe operating, Precautions, Before operation checks operation
ENGLISH
BEFORE OPERATION CHECKS
OPERATION
IS YOUR ENGINE READY TO GO?
SAFE OPERATING PRECAUTIONS
STARTING THE ENGINE
Check the General Condition of the Engine
Check the Engine
FUEL VALVE LEVER
C
C
H
H
O
O
K
K
E
E
L
L
E
E
V
V
E
E
R
R
O
O
N
N
O
O
N
N
C
C
L
L
O
O
S
S
E
E
D
D
O
O
P
P
E
E
N
N
C
C
L
L
O
O
S
S
E
E
D
D
3
Review the instructions provided with the equipment powered by
this engine for any safety precautions that should be observed
with engine startup, shutdown or operation.
Move the fuel valve lever to the ON position.
To start a cold engine, move the choke lever to the CLOSED
position.
Carbon monoxide gas is toxic. Breathing it can cause
unconsciousness and even kill you.
Avoid any areas or actions that expose you to carbon
monoxide.
Improperly maintaining this engine, or failure to
correct a problem before operation, can cause a
malfunction in which you can be seriously hurt or
killed.
Always perform a pre-operation inspection before
each operation, and correct any problem.
Before beginning your pre-operation checks, be sure the engine is
level and the engine switch is in the OFF position.
Always check the following items before you start the engine:
Look around and underneath the engine for signs of oil or
gasoline leaks.
Remove any excessive dirt or debris, especially around the
muffler and recoil starter.
Look for signs of damage.
Check that all shields and covers are in place, and all nuts, bolts,
and screws are tightened.
Check the fuel level (see page
). Starting with a full tank will
help to eliminate or reduce operating interruptions for refueling.
Check the engine oil level (see page
). Running the engine
with a low oil level can cause engine damage.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below safe limits. However,
to avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.
Check the air filter element (see page
). A dirty air filter
element will restrict air flow to the carburetor, reducing engine
performance.
Check the equipment powered by this engine.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
be followed before engine startup.
For your safety, and to maximize the service life of your
equipment, it is very important to take a few moments before you
operate the engine to check its condition. Be sure to take care of
any problem you find, or have your servicing dealer correct it,
before you operate the engine.
To restart a warm engine, leave the choke lever in the OPEN
position.
Before operating the engine for the first time, please review the
SAFETY INFORMATION section on page
and the
BEFORE
OPERATION CHECKS on this page.
1.
2.
1.
2.
3.
4.
3.
4.
1.
2.
07/06/01 17:16:35 32Z4C600_003