Hustler Turf 929125 - Manual (Page 8)

1-2 110907 01/09
Hardware Description Codes & Abbreviations
The following codes are used throughout this parts manual. Refer to this list when ordering parts.
Standard Torques
The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap
screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener
NOTE:
Loctite 592 to be used on all pipe threads.
Lubricate all grease zerks.
ABBREVIATION DESCRIPTION ABBREVIATION DESCRIPTION
CB Carriage Bolt MB Machine Bushing
CE Clevis Pin MS Machine Screw
CP Cotter Pin NT Nut
CN Clip Nut SC Self Tapping Cap Screw
CS Cap Screw SH Socket Head
CW Cup Washer SB Shoulder Bolt
FDRW Fender Washer SS Set Screw
FW Flat Washer OD Outside Diameter
HX Hex Head ID Inside Diameter
LW Lock Washer
SIZE FT-LBS NM SIZE FT-LBS NM
.250 8.2 11.1 M3 1 1.3
.312 17 23 M4 2.2 3
.375 30 40 M5 4.5 6.1
.438 48 65 M6 7.7 10.4
.500 73 99 M8 18.5 25
.562 105 143 M10 37 50
.625 145 200 M12 64 87
.750 260 350 M16 160 215
.875 420 565 M20 320 435
1.00 625 850 M24 555 750