Hitachi 51F520 - Manual (Page 31)

31
HOW TO USE THE REMOTE
TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR
(refer to page 32 for pre-codes).
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. To switch to VCR pre-coded mode, press and release the VCR button.
4. Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 32.
Release the VCR button.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code
is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different four digit
preset code.
6. The remote will now control your VCR.
NOTES:
1.
If your VCR cannot be operated after performing the
above procedures, your VCR’s code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. Press the Record button twice to record.
ቢ
VCR button
This button allows the remote to control your VCR player by
setting it to VCR mode.
ባ
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
ቤ
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
ባ
ቢ
ቤ
ባ
ባ
ባ
ቤ
ባ
MY VCR CODE IS:
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
THE REMOTE CONTROL