Installing memory cards, Installing memory cards -9 – Honeywell DOLPHIN 6500 User Manual
Page 25
3 - 9
•
4KHz–72db
Stylus
Dolphin 6500 terminals ship with a stylus inserted in a loop on the hand strap. Store the stylus
in the hand strap when you’re not using it; see
Installing Memory Cards
The Dolphin 6500 supports Secure Digital (SD) memory cards from 512MB up to 8GB in capacity. The
recommended SD cards are 2GB and 4GB ATP
®
-brand, which have been tested for reliability. You can
purchase these SD cards by contacting your Honeywell sales representative.
To install an SD card:
1.
Remove the battery door on the back of the unit.
2.
Remove the battery.
3.
Insert the SD card with the label facing upward by pressing down the small pin and sliding the SD
card into the SD card connector until you feel it lock into position. The notch on the SD card should
be in the upper-right hand corner.
Note: If your unit has trouble reading the SD card, the SD card may not have been inserted correctly. If depressing
the small pin allows the card to eject, the card was not properly inserted and “locked in.”
4.
Replace the battery and battery door.
5.
Tap the Power or SCAN key to resume operation.
6.
To verify that the operating system recognizes the new memory card, open Windows Explorer and
navigate to My Device\Storage Card.
To remove an SD card:
1.
Remove the battery door on the back of the unit.
2.
Remove the battery.
3.
Press the SD card towards the front of the terminal until you hear a click to confirm that it has
unlocked. The card will stops when it hits the pin.
4.
Depress the small pin at the edge of the card. The card will pop out enough for you to grab its edge.
SD Card
Pin
SD Card