Fusion F300S User Manual
Installation, operation, and maintenance
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- F300S/F300SQ Ultraviolet Lamp System
- Installation, Operation, and Maintenance
- Table Of Contents
- Introduction
- Chapter 1. Safety
- Chapter 2. Mechanical Installation
- Chapter 3. Electrical System
- Electrical Installation/Setup Checklist
- Accessory Parts List
- Interconnect Cables
- Connection and Program Log
- Power Supply Programming
- Single Unit Programming and Connections
- Programming
- Output Ports (J105B)
- Multiple-Unit Programming and Connections
- Power Source
- F300S Relay Coil Resistor Assembly Installation
- Chapter 4. Operation
- Chapter 5. Troubleshooting
- Chapter 6. Maintenance
- I300M Irradiator
- Bulb, Screen, and Reflector Maintenance
- I300M Screen Assembly Removal/Replacement
- Figure 19. Reflector Assembly (I300M)
- Figure 20. RF Screen Screw Tightening Sequence
- Lamp Bulb Removal/Replacement
- Figure 21. Removing or Replacing the Bulb
- Reflector Removal/Replacement
- Figure 22. Gasket Installation
- Figure 23. Reflector Removal or Replacement (I300M)
- Figure 24. Reflector Screw Tightening Sequence
- Figure 25. Correct Reflector Alignment (I300M)
- Figure 26. RF Screen Screw Tightening Sequence (I300M)
- I300M Irradiator Housing Removal/Replacement
- Figure 27. I300M/I301M Irradiator Component Location
- Direct View Photoresistor Removal/Replacement
- Figure 28. Photoresistor Assembly for Direct View (I300M)
- Filament Transformer Removal/Replacement
- Magnetron Removal/Replacement
- Figure 29. Magnetron Fastener Tightening Sequence (I300M)
- Air Pressure Verification
- Figure 30. Air Pressure Test Points (I300M) - I300 MB Similar
- I310M/I311M Irradiator
- Bulb, Screen, and Reflector Maintenance
- Figure 31. Reflector Assembly (I310M/I311M)
- Screen Assembly Removal/Replacement
- Lamp Bulb Removal/Replacement
- Figure 32. Removing or Replacing the Bulb (I310M/I311M)
- Reflector Removal/Replacement
- Figure 33. Reflector Removal or Replacement (I330M/I311M)
- Figure 34. Gasket Installation (I330M/I311M)
- Figure 35. Correct Reflector Alignment (I310M/I311M)
- Figure 36. Reflector Screw Tightening Sequence (I310M/I311M)
- Figure 37. RF Screen Screw Tightening Sequence (I310M/I311M)
- Figure 38. Gasket Installation with Cross-guide (Short) Gaskets (I310M/I311M)
- I310M/I311M Irradiator Housing Removal/Replacement
- I310M/I311M Scatter View Photoresistor Removal/Replacement
- Figure 39. I310M/I311M Irradiator Component Location (Scatter View)
- Direct View Photoresistor Removal/Replacement
- Figure 40. I310M-D/I311M-D Irradiator Component Location (Direct View)
- Figure 41. Photoresistor Assembly for Direct View (I300M)
- Filament Transformer Removal/Replacement
- Magnetron Removal/Replacement
- Figure 42. Magnetron Fastener Tightening Sequence
- Air Pressure Verification
- Figure 43. Air Pressure Test Points
- P300M/P300MQ Power Supply
- P300MT Power Supply
- K300 Modular Blower
- I300M Irradiator
- Appendix A. Specifications
- Appendix B. Cables and Connectors
- Appendix C. Outline Drawings
- Figure 50. P300M/P300MQ Power Supply Dimensions and Clearances
- Figure 51. P300MT Power Supply Dimensions and Clearances
- Figure 52. I300M Irradiator Dimensions
- Figure 53. I300MB Irradiator Dimensions
- Figure 54. I310M/I310M-D Irradiator Dimensions
- Figure 55. I310MB/I310MB-D Irradiator Dimensions
- Figure 56. I311M/I311M-D Irradiator Dimensions
- Figure 57. RF-1 RF Detector Dimensions
- Appendix D. Lamp System Maintenance Log
- Appendix E. Replacement Parts
- Appendix F. Ignitor Bulb
- Appendix G. Schematics