FUJITSU M3096EX - Manual (Page 32)

4 – 5
4.3 Reading Documents in ADF Mode
This section explains how to read documents using the automatic
document feeder. If the following steps are not closely followed, a
feed error may occur.
①
Check the documents as follows:
(a) Paper quality
• Wood-free paper.
• PPC paper; Specified by XEROX Corporation.
(b) Paper weight
• 13.91bs to 27.81bs
(c) Paper size
• Letter, Double Letter, Legal, A3, A4, A5, B4, B5
(d) Items to avoid
• The following documents may be hard to read by ADF. Before
you start the large quantity reading, check that the document is
read appropriately. If the reading is not appropriate, read them
by flatbet.
– Paper with a clip or staple.
– Paper that has ink which is not dry.
– Paper thickness is not constant, such as an envelope.
– Paper that has large rumples or curl. (See NOTICE)
– Paper that has folds or tears.
– Tracing paper.
– Coating paper.
– Carbon paper.
– Paper that is smaller than A5 size or larger than A3 width.
– Items other than paper, such as clothes, metal sheet, or OHP
film.
– Photographic paper.
– Paper that has perforations on its side.
– Paper that has a shape other than square.
– Paper that is very thin.
NOTICE : The important document which shall not be torn must be
read by flatbet.
NOTICE : Carbonless papers have the chemical composition which
damages the pad and pickroller. Therefore, note the follow-
ing remarks.
Cleaning : If the miss pick occurs frequently, clean the pad
and pickroller in accordance with the section
5.3.2.
Replacement of parts : The life of the pad and the pickroller
may be shorter than the case that PPC document
is fed. Replacement cycle of the pad and the
pickroller may be 100,000 sheets or more if the
paper quality is good and cleaning is done well.
Before you start the large quantity reading,
check the replacement cycle of them and prepare
pads and pickrollers.