FUJITSU M3096EX - Manual (Page 42)

5 – 5
③
Insert the pad assembly into the ADF frame hole (the bigger one),
slide the assembly to the direction of the arrow until it clicks.
ADF frame
Pad assy
NOTICE : Set the paper select lever to "N", before removing pad ASY
(See Section 4.3).
NOTICE : Pad can be replaced by aligning the holes of the pad with
the pins of the pad holder.
Pick spring
Pad
Pad holder
5.4.3 Replacing pick roller
Replace the pickroller as follows.
(a) Pull the cap up to open the ADF
unit.
(b) Remove two thumb screws shown
in Figure 5.4. And remove the
Guide A.
Figure 5.4 Pick Roller replacement
Guide A
Thumb Screw
Thumb Screw
Cap