FRIGIDAIRE 5-10 - Manual (Page 9)

Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Only
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Only
9
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
YOU WILL SEE:
Air Conditioner Features
(continued)
HEATING FEATURE : (on some models)
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Heat” Mode, the
fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55°F
(13°C) and 80°F (27°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample
the room air.
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should know.
The Remote Control will operate all the control panel features, follow the same instructions.
The control will maintain any set temperature between 60F and 90F degrees (cooling), 55F and 80F (heating).
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from
one to the other, press and hold the Up and Down Temperature Selection Pads at the same time for 3
seconds.
?
?
?
?
The "Cool "circuit has an automatic3 minute time delayed start if the unit is turned off
and on quickly. This prevents overheating of the compressor and possible circuit
breaker tripping. The fan will continue to run during this time.
! !
FAULT CODES
If the display reads “AS”, a sensor
has failed. Contact your Authorized
Frigidaire Service Center
If the display reads “HS”, a sensor
has failed. Contact your Authorized
Frigidaire Service Center
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Only
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
Auto Temp
Med
Hi
Lo
Heat
Energy Saver
Cool
Fan Only
TO TURN UNIT OFF: YOU WILL SEE:
DO THIS:
PRESS
ON/OFF BUTTOT
C h e c k
F i l t e r
S l e e p
T e m p /T i m e r
T e m p /T i m e r
R e m o te
S e n s in g
T i m e r
M o d e
F a n
S p e e d
Auto Temp
Med
Hi
L o
Heat
E nergy S aver
C ool
Fan Only
C h e c k
F i l t e r
S l e e p
T e m p /T i m e r
T e m p /T i m e r
R e m o te
S e n s in g
T i m e r
M o d e
F a n
S p e e d
Auto Temp
Med
Hi
L o
Heat
E nergy S aver
C ool
Fan Only
C h e c k
F i l t e r
S l e e p
T e m p /T i m e r
T e m p /T i m e r
R e m o te
S e n s in g
T i m e r
M o d e
F a n
S p e e d
Auto Temp
Med
Hi
L o
Heat
E nergy S aver
C ool
Fan Only
If the display reads “ES”, a sensor
has failed. Contact your Authorized
Frigidaire Service Center