FRIGIDAIRE 318201724 User Manual

30" electric range installation instructions

Advertising
background image

1

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

1. Clearances and Dimensions

a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must

be solid and level.

* 30" minimum clearance between the top of the cooking surface

and the bottom of an unprotected wood or metal cabinet; or 24 "
minimum when bottom of wood or metal cabinet is protected by not
less than ¼" flame retardant millboard covered with not less than
no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum
or 0.020" copper. The minimum clearance is 0" for the rear of the
range. Follow all dimension requirements provided above to prevent
property damage, potential fire hazard, and incorrect countertop
and cabinet cuts.

Avoid locating cabinet storage space above the surface units

to eliminate the possibility of cabinets catching on fire, or

personal burns from reaching for the cabinets over the heated

units. If cabinet storage is to be provided, risk can be reduced by

installing a range hood that projects horizontally a minimum of

5" beyond the bottom of the cabinets.

Printed in United States

318201724 (0904) Rev. A

FRONT

VIEW

BACK

VIEW

1/8

FRONT

VIEW

TYPICAL CABINET INSTALLATION

SIDE

VIEW

Important Notes to the Installer

1. Read all instructions contained in these installation instructions

before installing the appliance.

2. Remove all packing material before connecting the electrical

supply to the appliance.

3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your Use and Care Guide for future reference.

All dimensions for

electrical outlet

location are maximum.

Cubed area shows
where the electrical
outlet must be
installed for the
range to be flush to
the wall.

Wall

Edge

Terminal

Block

Location

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other

flammable vapors and liquids in the vicinity of this or any other appliance.

Canada

United States

Advertising