Operating instructions, Removing collected water – FRIGIDAIRE USE&CARE 2020264A0525 User Manual

Page 5

Advertising
background image

5

2009 Electrolux Home Products, Inc.

All rights reserved.

1. To shut the unit down, rotate the humidity knob to the OFF position.

Removing Collected Water

1. Emptying the Bucket:

a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.

Operating Instructions

Operating Instructions

(continued)

While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light.

NOTE:

b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.

e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the correct position

Discard water from bucket. Water is not potable and cannot be used for drinking.

WARNING

If the bucket full light does not extinguish, check that the float is
correctly snapped in place as indicated by the diagram.

The foam embedded under the float(shown in the sideward
diagram) is a functional part, which can not be removed.

NOTE:

Foam

Advertising