FujiFilm 3000 - Manual (Page 33)

31
No.
8
9
10
11
13
14
15
16
17
18
12
• Set the contrast level to lighter position to reduce the
density.
• If the images on the original are too dark, change to a
better copy of the original where possible.
• Check that the type of paper indicated on the message
display matches the type actually being used.
• Open the cover of the printer and check to see if the paper
is caught in the paper feed rollers.
• Check that the printer cover is closed properly.
• Place the original into the document bay until it stops.
• The printer will not scan transparent documents. Make a
copy on plain paper and restart the process.
• Check to see if an error message appears on the message
display.
• Clean the thermal heads.
• Clean the platen glass in the scanner unit.
• Open the scanner cover and remove the original.
• Check that the scanner cover is closed properly.
• If a document jam occurs again, check that the original has
been set properly.
• The printer automatically switches to a lower speed when
the thermal heads overheat. This typically occurs when
printing posters with large black areas or when printing in
reverse mode. This is normal, and does not indicate an
error in the printing process.
• A black band is printed on the direct thermal paper, to
indicate that the paper roll is nearly finished. Change the
paper roll when the band appears.
• Clean the shuttle shaft.
• Remove the packaging material in the shuttle shaft unit.
• Check that the type of paper indicated on the message
display matches the type actually being used.
• Check that the type of paper indicated on the message
display matches the type actually being used.
• Change the setting in function mode ('IMAGE DIRECTION')
to 'NORMAL'.
• Remove the protective covering on the control panel.
Tone of the images can not be
reproduced in darker areas.
The printed poster does not appear.
The printer does not start to print even
after the start/stop key has been
pressed.
Spots or marks appear in the margin area.
A document jam occurs.
The printing process is unexpectedly
slow.
(An “SLOW MODE” message will appear
on the display.)
A black band appears on the back of the
print.
The printer makes a rattling or grating
noise, or the “SHUTTLE ERROR”
message appears on the display.
The ink sheet (thermal transfer paper,
HDP paper) has a lot of wrinkles in it.
White bubbles appear on the printed
surface (thermal transfer paper, HDP
paper).
The poster is printed as a mirror image
of the original.
Low contrast on the message display.
P11
P11
P12
P15
P29
P32
P33
P15
P15
P17
P32
P2
P11
P11
P22
P10
Description Remedy Ref.
7
9