Operating instructions, Fault codes, Removing collected water – FRIGIDAIRE 2020266A0107 User Manual

Page 6

Advertising
background image

6

Operating Instructions

2009 Electrolux Home Products, Inc.

All rights reserved.

Fault Codes

1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.

Removing Collected Water

1. Emptying the Bucket:

a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.

b. Do not move the unit at this point otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.

e. Replace the empty bucket back into the unit and once seated correctly the unit will start up again.
f. You should hear a click when the bucket is in the correct position

Discard water from bucket. Water is not potable and cannot be used for drinking.

WARNING

Advertising