FORD 2005 Crown Victoria - Manual (Page 59)

Reprogramming a single HomeLink ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired
HomeLink
௡ button. DO NOT
release the button. The display will
read CHANNEL “X” (1,2 or 3)
TRANSMIT
2. The display will change to
CHANNEL “X” (1,2, or 3)
TRAINING after 20 seconds.
Without releasing the HomeLink
௡
button, follow step 2 in the
“Programming” section.
For questions or comments, contact
HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
AUXILIARY POWER POINT (12VDC)
The auxiliary power point for five passenger vehicles is located in the floor
console storage bin. For six passenger vehicles, the auxiliary power point is
located under the cup holder and ashtray drawer in the center stack.
Do not plug optional electrical accessories into the cigarette lighter. Use
the power point.
Do not use the power point for operating the cigarette lighter element.
The maximum power each power point can supply depends on the fuse
rating. For example: a 20A fuse should supply a maximum of 240 Watts,
a 15A fuse should supply a maximum of 180 Watts and a 10A fuse should
supply a maximum of 120 Watts. Exceeding these limits will result in a
blown fuse.
Always keep the power point caps closed when not being used.
Power outlets are designed for accessory plugs only. Do not hang any
type of accessory or accessory bracket from the plug. Improper use
of the power outlet can cause damage not covered by your warranty.
2005 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA_English (fus)
Driver Controls
59