Solutions to common problems, Ice dispenser, Water dispenser – FRIGIDAIRE 241540101 User Manual

Page 39

Advertising
background image

39

Solutions To Common Problems

Ice Dispenser

Problem Cause

Correction

Dispenser will not

dispense ice.

• Water supply is not connected.
• Ice storage container is empty.

• Freezer temperature is set too warm.

• Household water line valve is not

open.

• Freezer door is not closed.
• Ice dispensing arm has been held in

for more than 4-5 minutes.

• Connect water supply (see page 9).
• When the first supply of ice is dropped into the container,

the dispenser should operate.

• Turn freezer control to a higher setting so that ice cubes

will be made. When first supply of ice is made, dispenser

should operate.

• Open household water line valve. Allow sufficient time for

the ice to be made. When ice is made, the dispenser

should operate.

• Ensure freezer door is closed.
• Motor is overloaded. Motor overload protector will reset in

approximately 3 minutes. Ice can then be dispensed.

Ice dispenser is

jammed.

• Ice has melted and frozen around

auger due to infrequent use,
temperature fluctuations, and/or

power outages.

• Ice cubes are jammed between ice

maker and back of ice container.

• Ice cubes are frozen together.

• Ice cubes are hollow or smaller than

normal.

• Remove ice container, thaw, and empty the contents.

Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.

• Remove ice cubes that are jamming the dispenser.

• Use the dispenser often so that cubes do not freeze

together.

• The ice & water filter cartridge could be clogged. Replace

the filter cartridge. Dispensing system operates best at 20-
100 psi water pressure. Well water pressures should fall

within this range.

Water Dispenser

Problem Cause

Correction

Dispenser will not

dispense water.

• Water supply is not connected.
• Household water line valve is not

open.

• Freezer door is not closed.
• Ice & water filter cartridge is clogged.
• Front filter not fully installed, if

equipped

• Connect water supply (see page 9).
• Open household water line valve. See Problem section Ice

Maker Is Not Making Ice.

• Ensure that freezer door is closed.
• Replace filter cartridge.
• Push filter in until you hear a “click”. Filter should be flush

with cabinet.

Water has an odd

taste and/or odor.

• Water has been in the tank for a

period of time.

• Unit not properly connected to cold

water line.

• Tubing used in the household water

supply and installation may affect
water taste and odor.

• Water has a high mineral content.

• Draw and discard 10-12 glasses of water to freshen the

supply and completely rinse out the tank.

• Connect unit to cold water line that supplies water to the

kitchen faucet.

• For best results, use copper tubing for water connections.


• Contact water treatment plant for help.

Water pressure is

extremely low.

• Cut-off and cut-on pressures are too

low (well systems only).

• Reverse osmosis system is in

regenerative phase.

• Have someone turn up the cut-off and cut-on pressure on

the water pump system (well systems only).

• It is normal for a reverse osmosis system to be below 20

psi during the regenerative phase.

Advertising