Solutions to common dishwashing problems – FRIGIDAIRE 500 User Manual

Page 13

Advertising
background image

13

Solutions to Common Dishwashing Problems

(continued)

Dishwasher Leaks

• Use only fresh detergent designed for

automatic dishwashers. Measure detergent

carefully. Try a different brand.

• Spilled rinse aid can cause foam and lead to

overflowing. Wipe up any spills with a damp

cloth.

• Check to see that dishwasher is level. (See

Installation Instructions.)

Normal Sounds You Will Hear

• Normal sounds include water fill, water

circulation and motor sounds.

• There is a noticeable change in sound when

the wash action switches between the lower

and middle spray arm. This is normal since

each spray arm has its own sound.

• It is normal for dishwasher to pause (no

sound) when the wash action is switching

between the lower and middle spray arms.

Water in Bottom of Tub

• Water left in bottom of tub after cycle is

complete is not normal. If water remains in

the bottom of the tub, dishwasher may not be

draining properly. (See Dishwasher Does

Not Drain Properly.)

Vapor at Vent

• Water vapor escapes from the vent during

the washing and/or drying part of cycle. This

is normal.

Dishwasher Won’t Run

• Check to see if circuit breaker is tripped or if

a fuse is blown.

• Make sure water supply is turned on.
• Check to see if cycle is set correctly. (See

Operating Instructions.)

• Is dishwasher set for delay start option?
• Make sure door is closed and latched.

Dishware Stained or Discolored

• Tea and coffee can stain cups. Remove the

stains by hand washing in a solution of 1/2

cup (120 ml) bleach and one quart (1 L) of

warm water. Rinse thoroughly.

• Iron deposits in water can cause a yellow or

brown film. A special filter installed in the

water supply line will correct this problem.

(See Removing Spots and Film.)

• Aluminum utensils can leave gray/black

marks when they rub against other items.

Load properly.

• Certain high acid foods can cause

discoloration of stainless steel and plastics if

allowed to sit for a long period. Use the

Rinse/Hold cycle or rinse by hand if not

operating dishwasher at once.

• Mixing stainless steel and silver utensils in

silverware basket can cause pitting of the

stainless steel blades. Avoid mixing stainless

steel and silver.

Etching

• Using too much detergent in soft or softened

water causes this film that cannot be

removed.

• Adjust the amount of detergent based on the

water hardness. (Check Detergent Chart.)

• Lower the water temperature.
• Use the Heat Dry Off option.

Detergent Left in Cups

• Detergent may be old. Discard and use fresh

detergent.

• Be sure water action can reach the

dispenser.

• Check to see if cycle has been completed.
• Make sure items do not prevent the detergent

dispenser from opening.

Advertising