FRIGIDAIRE 154768501 - Manual (Page 8)

8
OPERATING INSTRUCTIONS
Status Indicator Lights
The CLEAN light will come on at end of cycle and remain
on until door is opened.
When the SANITIZE option is selected, the SANITIZED
light will glow when the SANITIZE cycle is finished and
remain on until the door is opened. If the dishwasher did
not properly sanitize the dishes, the light will not come
on. This can happen if the cycle is interrupted or if
incoming water temperture is below 120
o F.
The WASHING light comes on at the beginning of cycle
and remains on until the end of the main wash.
PF……………… Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL pad.
1H-24H……….. Number of delay start hours.
The last hour will count down
in minutes.
CL……………… Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
HO or Hd…..… Indicate a water heat delay.
MINUTES…...… Number of minutes left in cycle
(1-99). If cycle is longer than
99 minutes, a small plus sign
will appear beside the number
of minutes and remain on until
time counts below 99.
The RINSING AGENT LOW light, Located near the
Rinse Only Pad, comes on at the end of a cleaning cycle
when the rinse agent reservoir is low. The light will
remain on through 5 successive cycles or until the
reservoir is filled.
The DRYING light indicates the drying portion of the
cycle. The light will come on when either drying option is
selected.
In the unlikely event the dishwasher malfunctions, the
indicator may display one of the following codes "Er",
"uF", "uo", or "CE". If one of these codes are displayed
contact the Frigidaire Customer Care Center at
1-
800-944-9044
They will be able to provide
assistance in troubleshooting the problem and/or
locating an authorized service technician, if needed.
NOTE
The time remaining could suddenly increase or drop
several minutes. This means the Smart Sensor has
checked the soil level and determined if additional water
fills are needed or if water fills can be deleted.