Setting warm & serve drawer controls (some models), Setting oven controls – FRIGIDAIRE Dual Fuel Range Slide-in Models User Manual

Page 11

Advertising
background image

11

Warm & Serve

Drawer

Tiroir Réchaud

Warm & Serve Drawer

recommended Food Settings

Table

Food Item

Setting

Bacon

HI

Hamburger Patties

HI

Poultry

HI

Pork Chops

HI

Fried Foods

HI

Pizza

HI

Gravies

MED

Casseroles

MED

Eggs

MED

Roasts (Beef, Pork, Lamb) MED
Vegetables

MED

Biscuits

MED

Rolls, hard

MED

Pastries

MED

Rolls (soft)

LO

Empty Dinner Plates

LO

Warm & Serve Drawer Temperature Selection

Recommended Warm & Serve Drawer settings table is shown aside. If a particular
food is not listed, start with the MED setting. If more crispness is desired, remove
the lid or aluminum foil from the food. Most foods can be kept at serving
temperatures on the MED setting. When a combination of foods are to be kept
warm (for instance, meat with 2 vegetables and rolls), use the HI setting. To avoid
heat loss, do not open the Warmer Drawer while in use.

To Set the Warm & Serve Drawer Controls:

The control and indicator lights for the Warm & Serve Drawer features are located
on the control panel. The temperatures are approximate, and are designated by HI
(high), MED (medium) and LO (low).

1. Touch the

pad at the Warm & Serve Drawer control position (see Figure

4). The Warm & Serve Drawer indicator light will flash. Note: If no further pads
are touched within 25 seconds the request to power the Warm & Serve Drawer
ON will clear.

2. Set the desired power level. Touch

once to turn ON the power level for

HI (see Figure 1) or

to turn ON the power level for LO (see Figure 3). The

Setting Warm & Serve Drawer Controls (some models)

Refer to the Electronic Oven Control Guide for oven settings.

Setting Oven Controls

Figure 4

Figure 1

Figure 2

Figure 3

Warm & Serve Drawer indicator light located beside the

pad will turn ON steady.

3. Each touch of the

or

pads will decrease or increase through 6 power levels from HI

(see Figure 1) to MED (see Figure 2) to LO (see Figure 3). Note: For best results, preheat the Warm
& Serve Drawer before adding the food . An empty drawer will preheat in approximately 15 minutes.

4. When the food is ready for removal, touch the

pad once to turn the Warm & Serve

Drawer OFF. The Warm & Serve Drawer
indicator light will turn OFF.

Note: The Warm & Serve drawer is equipped
with a catch which may require extra force when
opening and closing the drawer.

Advertising