FRIGIDAIRE Outdoor Kitchen Grill - Manual (Page 15)

ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the rotisserie
counter clockwise to the “HIGH” position. Wait 5 seconds.
Then press and hold the electronic igniter button. You’ll
hear a snapping sound. If the burner does not light in 4
seconds, turn the control knob to OFF and wait 5 minutes
before trying again. Once lit, turn the control knob to the
desired setting. (See Fig. 18)
MATCH LIGHTING
If by chance the electronic igniter does not light the burner,
the burner may be lit with a match. Attach the match to the
match extender, located inside the right cart door.
Keep your face as far away from the grill surface as possible
and hold a match, attached to the match extender, to the
burner, then push and turn the control knob counter clockwise
to the “HIGH” position. (See Fig. 19)
NOTE: After the first use the stainless steel around the
burner will darken. This is a normal reaction of premium
stainless steel to heat and is not a defect. The infrared
panel will also darken after initial use. This is also a
normal occurrence.
SIDE BURNER LIGHTING
Push and turn the control knob to the “HIGH” position and
immediately press and hold the electronic igniter button.
You’ll hear a snapping sound. It may be necessary to hold
the electronic starter button for about 4 seconds. If the
burner does not light in 4 seconds, turn the knob to the
“OFF” position and wait 5 minutes before trying again.
Repeat above steps to light remaining burners.
(See Fig. 20)
MATCH LIGHTING
If by chance the electronic igniter does not light the burner,
the burner may be lit with a match. Attach the match to the
match extender, located inside the right cart door.
Keep your face as far away from the grill surface as possi-
ble and hold a match, attached to the match extender, near
the burner ports
, then push and turn the control knob count-
er clockwise to the “HIGH” position.
15
Fig. 18
Fig. 19
Fig. 20
Using the Rotisserie & Side Burners
NOTE: Do Not operate the main
burners and infrared back burner at
the same time. This can cause
warping of the roll top grill hood.
!