GE Profile PP989DN User Manual
Pp989dn, Ge profile, 30" downdraft electric cooktop
Dimensions and Installation Information
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
Listed by
Underwriters
Laboratories
PP989DN
GE Profile
™
30" Downdraft Electric Cooktop
Specification Created 7/08
220977
Wall Installation: Wall installations
require 25” countertop depth. When
cabinet is flush against the wall, the
fan housing can be rotated to the
horizontal position for direct venting
through rear wall. Make a countertop cutout in the range
cabinet according to unit dimensions and installation type.
Duct hole is positioned in back of cabinet for through-the-
wall ducting. Requires special offset adapter JXRW89.
Peninsula or Island Installation: For peninsula/islands a
minimum 26” countertop depth is suggested. Blower should
be in vertical position. Island or peninsula cabinets may
require adjustment in cutout depth and/or location within
the width dimensions. Duct hole is positioned in bottom of
cabinet for island or peninsula installation.
Slab Installation: For peninsula or island installation and
rear wall ducting,
6” PVC duct or locally approved piping
should be used if installing under a poured concrete slab.
Receptacle Location: Install an approved junction box
within shaded area shown in diagram. Junction box must
be at least 10-1/2" below top of cabinet.
Installation Information: Before installing, consult installation
instructions, packed with product, for current dimensional
data.
Note: Electrical cable is not supplied with unit.
These cooktops are approved for indoor use only.
KW Rating
240V
9.1
208V
6.9
25
1-7/8"
MIN. Required*
20-5/8
Cut-out Dimensions (in inches)
28-7/8
*U.L. Requirement.
Note: A 6" minimum spacing to adjacent side wall is required
20
9
4
10-1/2
16
C
L
Cabinet Dimensions (in inches)
*Note: A 6" minimum spacing to adjacent side wall is required
Dimension and installation information are shown in inches.
22
7
⁄
16
ʺ
(22
9
⁄
16
ʺ SS)
20
1
⁄
2
ʺ
22ʺ
29
7
⁄
8
ʺ
(30ʺ SS)
2
3
⁄
16
ʺ
(2
1
⁄
4
ʺ SS)
28
3
⁄
4
ʺ