Graco Inc. 1095 Premium Hi - Manual (Page 10)

Startup
10 3A0156A
Startup
1. Turn pressure control to lowest pressure.
2. Turn power ON.
3. Increase pressure 1/2 turn to start motor and allow
fluid to circulate through drain tube for 15 seconds;
turn pressure down.
4. Turn prime valve forward to SPRAY position. Disen-
gage gun trigger safety.
5. Hold gun against grounded metal flushing pail. Trig-
ger gun and increase fluid pressure 1/2 turn. Flush
1 minute.
6. Inspect for leaks. Do not stop leaks with hand or a
rag! If leaks occur, perform Pressure Relief Proce-
dure, page 8. Tighten fittings. Perform Startup,
steps 1 - 5. If no leaks, proceed to step 7.
7. Place pump in paint pail.
8. Trigger gun again into flushing pail until paint
appears. Move gun to paint pail and trigger for 20
seconds. Set gun safety ON. Assemble tip and
guard, see instructions on next page.
ti4266a
ti4266a
1/2
15sec .
ti14845a ti10167a
ti4271a
1/
2
ti13243a
PAINT
ti2714a
ti13029a
ti10166a