GE DE68-02957A - Manual (Page 16)

USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
B3.
•
Read the instructions on the TOP CABINET
TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
The top cabinet template will help you locate the top
support screw holes and power cord cutout.
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening the toggle bolts and the
wood screw(s), check again to be sure that the
mounting plate is level and centered left to right.
CAUTION:
Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
Tighten all bolts. Pull the plate away from the
wall to help tighten the bolts. Be careful not to
over-torque the toggle bolts.
3
4
2
1 Remove the back top center blower motor door
retaining screw.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST B4.
Open the blower door by lifting it up at the back
side of the microwave. Remove and save the top
and back retaining screws that hold the blower
motor in the microwave.
Back of
Microwave
Blower Motor
Blower Door
Screw
16
Retaining
screw
Retaining
screw
ATTACH THE MOUNTING
PLATE TO THE WALL B2.
Remove the template from the rear wall. The
mounting plate must be secured to the wall using at
least 3 toggle bolts and one wood screw. The wood
screw must engage a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3 ⁄
4
″ onto each bolt.
1
2