GE DE68-02957A - Manual (Page 21)

ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.) C3.
21
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Oven Top
Equivalent to Depth
of Cabinet Recess
Installation Instructions
3
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
NOTE: When mounting
the microwave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift
oven by pulling cord.
Lift microwave, tilt
it forward and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
Self-Aligning Screw
2 Rotate front of oven
up against cabinet
bottom.
1
Close the blower cover and secure it with the
screw removed in Step 1.
7 Secure the blower unit to the microwave with
the two screws removed in Step 2.
6 Tilt and place the blower unit back into the
opening in the top of the microwave.
8
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
Retaining
screw
Retaining
screw
C4.