GE CS980 - Manual (Page 46)

46
Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with
instructions for installation in a variety of
locations. The instructions include all necessary
information to complete the installation. Read
the Safety Instructions and the instructions
that fit your situation before beginning
installation.
WARNING:
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
• See instructions to install (supplied with bracket).
• Unless properly installed, the range could be
tipped by stepping or sitting on the door. Injury
may result from spilled hot liquids or from the
range itself.
9
Typical installation of anti-tip bracket attachment to wall
Bracket
Screw must
enter wood or
metal
Wall plate
REPLACE THE WIRE COVER
Replace the wire cover on the range back by
sliding its right edge under the retaining tab and
replacing the two screws removed earlier. Make
sure that no wires are pinched between the cover
and the range back.
8 LEVEL THE RANGE
Install the oven racks in the oven and position
the range where it will be installed.
Check for levelness by
placing a spirit level or a
cup, partially filled with
water, on one of the oven
racks. If using a spirit level,
take two readings—with the
level placed diagonally first
in one direction and then the other.
The rear leveling legs must be adjusted prior
to moving the range into position. They can
be adjusted from the bottom at the back
of the range.
Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
Replace the drawer or panel. E
D
C
B
A
10
Spirit level
Wire
cover
2 screws to
replace wire
cover
Retaining
tab
Back of range
Adjust from
the bottom back
of range (warming
drawer models)
Back of range
Leg
leveler
Lower
range
Raise
range