GE 71271 - Manual (Page 8)

8
How To Use
The GE Wet/Dry Vac is designed for various cleaning chores around the home. The accessories are sufficient to clean
a garage, workshop, or patio. Yet, the cleaner is gentle enough to use in the home. It will quickly pick-up spills, water in
a basement, or kitchen accidents.
NOTE: When an extension cord is used, make sure the plug connections does not come into contact with the liquid.
Never operate vacuum cleaner without motor filter(s) or with defective filter(s). Never use paper filter for
wet pick-up. See How To Maintain section for care of foam and paper filters. If operated for a prolonged
period of time, ear protection is recommended.
Dry Pick-Up
Use floor nozzle (without squeegee attached) or hose for dry pick-up cleaning.
Wet Pick-Up
Place squeegee into floor nozzle to pick-up water or spilled liquids. Filters should be clean for maximum cleaning
efficiency.
1. Push hose coupling with twisting motion into hose inlet.
2. Plug electrical cord into outlet.
Use extension cord (not provided) for models with short
electrical cord. Extension cord must be marked “Suitable
for use with outdoor appliances”.
NOTE: When an extension cord is used, make sure the plug
connection does not come into contact with any
liquid.
Use a grounded extension cord with 3-prong
plug and 3-pole receptacle; 16 gauge, SJTW-A type.
Loop the cords to prevent unplugging.
3. Push power switch to turn on.
NOTE: Detachable blower switch is located on top of blower
handle.
4. Place wand(s) onto hose and attach desired tool.
Power Switch
Hose
Coupling
Hose
Inlet