GE Profile P2S975DEP - Manual

For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000.
Specification Created 5/09 230141
Rear filler strip or backguard are available for
these ranges
Note: Door handle protrudes 3" from door face. Cabinets
and drawers on adjacent 45° and 90° walls should be
placed to avoid interference with the handle.
Note: Cabinets installed adjacent to slide-in
ranges must have an adhesion spec of at least
194° temperature rating.
Optional Kits for Slide-In Gas Ranges:
(Available at additional cost)
Lower/Side Trim Kits
JXS56BB - Lower Trim Kit (Black)
Accessory Backguards
JXS32BB - Black Accessory Backguard
JXS37BB - Black Glass Accessory Backguard
Rear Filler Strip
WB07T10680 - Black Filler Strip Assembly
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Dimensions and Installation Information (in inches)
P2S975DEP
GE Profile ™ 30" Dual Fuel Slide-In Gas Range
28-1/4*
36
Maintain
at least 6"
from nearest
combustible
surface.
Acceptable
Electrical
Outlet Area
30" Slide-In Range
Dimensions (in inches)
45-1/8
2-1/4
5
6
4-1/2
30
30" Min.
15" Min. 6
30" Slide-in Elec. Range
Aug. 8, 2003 -km
23-3/16
30
30
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
25
*Wall to front of
closed door handle
on model JSP34.
28" on models
JSP26/JSS26/16.
Note: Range may be placed with 0" clearance (flush) at the back wall and side walls
below countertop if the range side trims above the countertop extend beyond the cabinet
fronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearest
combustible surface.
30
31-1/2
28-1/4*
36
Maintain
at least 6"
from nearest
combustible
surface.
Acceptable
Electrical
Outlet Area
30" Slide-In Range
Dimensions (in inches)
45-1/8
2-1/4
5
6
4-1/2
30
30" Min.
15" Min. 6
30" Slide-in Elec. Range
Aug. 8, 2003 -km
23-3/16
30
30
If you are NOT using the
Filler strip or Backguard:
If you are using the
Filler strip or Backguard:
25
*Wall to front of
closed door handle
on model JSP34.
28" on models
JSP26/JSS26/16.
Note: Range may be placed with 0" clearance (flush) at the back wall and side walls
below countertop if the range side trims above the countertop extend beyond the cabinet
fronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearest
combustible surface.
30
31-1/2
Counter Cutout Dimensions (in inches)
2-7/8"
To Front
Surface Of
Countertop
20-5/8"
Door Clearance
From Front
Surface of
Countertop
31-1/4
30 A*
Accessory
Backguard
36
2"
(Grates)
24
Acceptable
Gas Line &
Electrical
Outlet Area
Max. depth of
cord, plug,
receptacle box
& gas hookup
3-1/2" to prevent
interference
with drawer
30" Min.
Shave Raised Edge To Clear
31-1/8 Wide Control Panel
30" Min. to
unprotected
cabinet from
countertop 23-3/16
18" Min.
13" Max.
3
29-15/16" Min.
30-1/16" Max.
25
9/16
7
12 15
*A – JXS37 is 5-1/4" and JXS32 is 4"
27-1/2**
44-3/4
(excluding handle)
**Total depth from wall to
front of closed oven door
including handle is 30-1/2.
B is 9-1/2" from walls on either side for P2S975, PGS975
and PGS908 and 6” for PGS968
B
35-7/8"–38"
from floor to
countertop
12″
23-3/16
″
7″
Acceptab
le Gas Line
& Electrica
l Outlet A
rea
30″ Min.
30″ Min.
from
cooking
surface to bottom
of overhead
cabinets
Shave Rais
ed Edge To Clear 3
1-1/8″ Wide Contr
ol Panel
9-1/2″ Min
.
From Wal
ls
13″
Max.
depth
For Opti
mum
Installat
ion Thes
e
Surfaces
Must
Be Flat &
Level
Follow ins
tructions
packaged w
ith
alternate a
ppliance
Countertop
Depth 25″ (typ
ical)
35-3/4
″ to 36
-1/2″
from
floor
to
count
ertop
18″ Min. vertical
distance from th
e bottom of the ad
jacent overhead cabine
ts
1-1/4″ Min. C
ounter top to top of dra
wer
Drawer
cord
, plu
g,
rece
ptac
le bo
x
3.5″
to pr
even
t
inter
feren
ce
& ga
s ho
okup
Max.
dept
h of
with
dra
wer
9/16″
29-15/
16″ Min
.
30-1/16
″ Max.
3″
15″
12″
23-3/16
″
7″
Acceptab
le Gas Line
& Electrica
l Outlet A
rea
30″ Min.
30″ Min.
from
cooking
surface to bottom
of overhead
cabinets
Shave Rais
ed Edge To Clear 3
1-1/8″ Wide Contr
ol Panel
9-1/2″ Min
.
From Wal
ls
13″
Max.
depth
For Opti
mum
Installat
ion Thes
e
Surfaces
Must
Be Flat &
Level
Follow ins
tructions
packaged w
ith
alternate a
ppliance
Countertop
Depth 25″ (typ
ical)
35-3/4
″ to 36
-1/2″
from
floor
to
count
ertop
18″ Min. vertical
distance from th
e bottom of the ad
jacent overhead cabine
ts
1-1/4″ Min. C
ounter top to top of dra
wer
Drawer
cord
, plu
g,
rece
ptac
le bo
x
3.5″
to pr
even
t
inter
feren
ce
& ga
s ho
okup
Max.
dept
h of
with
dra
wer
9/16″
29-15/
16″ Min
.
30-1/16
″ Max.
3″
15″