Garmin Edge 500 - Manual (Page 34)

0 Edge 500 Owner’s Manual
ANT+ Sensors
Third-Party ANT+ Sensors
For a list of third-party ANT+ sensors
that are compatible with the Edge, go
to www.garmin.com/intosports .
Calibrating Your Power Meter
For calibration instructions specific
to your power meter, refer to the
manufacturer’s instructions.
Before you can calibrate your power
meter, it must be properly installed and
actively recording data.
1. Press and hold
MENU .
2. Select Settings > Bike Settings
> [Bike 1] > ANT+ Power >
Calibrate .
3. Keep your power meter active by
pedaling until the message appears.
Viewing Your Power Zones
You can set seven custom power zones
using Garmin Connect or Garmin
Training Center. If you know your
FTP (functional threshold power)
value, you can enter it and allow the
software to calculate your power zones
automatically.
1. Press and hold
MENU .
2. Select Settings > Bike Settings >
[Bike 1] > Power Zones .
Non-Zero Averaging for Power
Data
The non-zero data-averaging setting
is available if you are training with
an optional power meter. The default
setting is to exclude zero values that
occur when you are not pedaling.
To turn the non-zero averaging on or
off, press and hold MENU , and select
Settings > Bike Settings > Data Avg .