The transducers, Ransducers, Длздмнй=сбзйдбну – Genesis I.C.E. 12t User Manual

Page 16

Advertising
background image

16

16

16

16

~ДлздмнЙ=СбЗЙдбну

The best amplifier for this application is a Class-D switching amplifier.
One of the reasons a Class-D amplifier is optimum for this application
is that it has a dramatically increased efficiency, especially at lower
frequencies. A typical Class A/B amplifier is only 50% efficient. A
Class-D amplifier, on the other hand, can be 90% efficient. A Class-D
amp also puts out more power with less heat and less power
consumption; ideal for use as a subwoofer amplifier.

The S2/12t uses a proprietary, ultra-efficient, discrete MOSFET
switching amplifier with output capability of up to a full kilowatt. The
design provides extraordinary control with high-damping and great
thermal stability, so that you can play the most demanding sources
continuously at high volume.

The Transducers
The transducer used in a servo system must be strong enough to
withstand the high current approach of the servo, and yet delicate and
light enough to react extremely quickly. The S2/12t subwoofer features
two 12-inch woofers that are designed with ribbed aluminum cones,
that are lightweight and yet inherently stiff. Our aluminum cones exhibit
no resonance or cone flexure anywhere near the frequencies at which
the subwoofer operates. The lowest break-up mode (where there can
be any chance of distortion at all) is at 6,000Hz – far above the 25Hz to
120Hz frequency response of the S2/12t. Therefore, the driver is a
perfect piston within the frequencies used, and exhibits very low cone-
breakup distortion.

Advertising
This manual is related to the following products:

2