Epson WorkForce 630 - Manual (Page 55)

Notices 55
Notices
Important Safety Instructions
Before using your Epson product, read and follow these safety instructions:
■ Be sure to follow all warnings and instructions marked on the product.
■ Use only the type of power source indicated on the product label.
■ Use only the power cord that comes with the product. Use of another cord may cause
fires or shock. Do not use the cord with any other equipment. Make sure the power
cord meets all relevant local safety standards.
■ Place the product near a wall outlet where the plug can be easily unplugged.
■ If you won’t be using the product for a long period, unplug the power cord from the
electrical outlet.
■ Always turn off the product using the P On button, and wait until the P On light
stops flashing before unplugging the product or cutting off power to the electrical
outlet.
■ Avoid plugging the product into an outlet on the same circuit as a photocopier or air
conditioning system that regularly switches on and off, or on an outlet controlled by a
wall switch or timer.
■ Do not let the power cord become damaged or frayed. Place it to avoid abrasions,
cuts, fraying, crimping, and kinking. Do not place objects on top of it and do not
allow it to be stepped on or run over. Be careful to keep the cord straight at each end.
If damage occurs to the plug, replace the cord or consult a qualified electrician.
■ If you use an extension cord with the product, make sure the total ampere rating of
the devices plugged into the extension cord does not exceed the cord’s ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet’s ampere rating.
■ When connecting the printer to a computer or other device with a cable, ensure the
correct orientation of the connectors. Each connector has only one correct
orientation. Inserting a connector in the wrong orientation may damage both devices
connected by the cable.
■ Place the product on a flat, stable surface that extends beyond its base in all directions.
It will not operate properly if it is tilted or at an angle.
■ Avoid placing the product in locations that are subject to rapid changes in heat or
humidity, shocks or vibrations, or dust. Do not place the product near a radiator or
heating vent or in direct sunlight. Do not place or store the printer outdoors.