Radar overlay display appearance – Garmin GPSMAP 740s User Manual

Page 73

Advertising
background image

GPSMAP 700 Series Owner’s Manual

69

Radar

Front-of-boat Offset

The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar

scanner does not align with the bow-stern axis.

Measuring the Potential Front-of-boat Offset

1. Using a magnetic compass, take an optical bearing of a stationary target located within viewable range.
2. Measure the target bearing on the radar.
3. If the bearing deviation is more than +/- 1°, set the front-of-boat offset.

Setting the Front-of-boat Offset

Before you can set the front-of-boat offset, you must measure the potential front-of-boat offset (see previous

procedure).
The front-of-boat offset setting configured for use in one radar mode is applied to every other radar mode and

to the Radar Overlay.
1. From the Home screen, select Radar > Radar Setup > Front of Boat.
2. Select and hold Up or Down to adjust the offset.

Radar Overlay Display Appearance

Showing Tracks on the Radar Overlay

You can set whether vessel tracks appear on the Radar Overlay.

From the Home screen, select Charts > Radar overlay > Menu > Waypoints & Tracks > Tracks > on.

Selecting a Waypoint Label Type

You can select the type of labels shown with waypoints on the Radar Overlay.
1. From the Home screen, select Charts > Radar overlay > Menu > Waypoints & Tracks > Waypoint

Display.

2. Select a waypoint.
3. Complete an action:

• Select Label to identify waypoints using labels.
• Select Comment to show comments as waypoint labels.
• Select Symbol to identify waypoints using symbols.

Showing Other Vessels on the Radar Overlay

AIS requires the use of an external AIS device and active transponder signals from other vessels.
You can configure how other vessels appear on the Radar Overlay. The display range setting configured for the

Radar Overlay is applied only to the Radar Overlay. The details and projected heading settings configured for

the Radar Overlay are also applied to all radar modes.
1. From the Home screen, select Charts > Radar overlay > Menu > other Vessels > AIS Display Setup.
2. Complete an action:

• Select AIS Display Range to indicate the distance from your location in which AIS vessels appear, and

select a distance.

• Select Details > Show to show details about AIS-activated vessels.
• Select Proj. Heading to set the projected heading time for AIS-activated vessels, and select Done.
• Select Trails to show the tracks of AIS vessels, and select the length of the track that appears using a

trail.

Advertising
This manual is related to the following products: