GE Monogram ZHU30RBMBB - Manual

For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000.
130255 Specification Created 09/08
Listed by
Underwriters
Laboratories
ZHU30RBM
GE Monogram ® 30" Electric Induction Cooktop
Dimensions and Installation Information (in inches)
Cutout Dimensions:
30" Models A B C D
ZHU30RBM 29-3/4" 21-3/8" 28-1/2" 19-5/8"
269Dia1
A
C
2" Min.
to Side Walls
B
2-1/2"
Min.
to Front
Edge
1-3/4"
Min.
D
269Dia2
3-1/4"
6-1/4"
5-1/2"
557ZEU669
16" Min
Junction
Box
Combination installations
Consideration must be given to electrical supply locations
when the cooktop is installed with other products in the same
cabinet. Always refer to each product's installation instructions
for clearances and electrical requirements.
• Install these cooktops with any exhaust hood of the same
or treater width; 300 CFM or greater air flow rating is
recommended.
• The 30" cooktop may be installed in combination with a
Monogram ® 30" downdraft vent. Install the 36" cooktop with
a 36" downdraft vent. See downdraft vents for details.
• A Monogram single oven (except Trivection oven) may be
installed below these cooktops.
The serial plate is located on the bottom of the cooktops.
Electrical requirements
Product rating is 120/240V, 60Hz, 36" cooktops
to a 50-amp circuit; and 30" cooktops to a 40-
amp circuit. The cooktops must be connected
to a supply circuit of the proper voltage and
frequency and protected by a time-delay fuse or
circuit breaker.
All models require 12" minimum clearance below
the cooktop bottom to combustible materials.