Garmin 110 - Manual (Page 90)

84 Rino ® 110 Owner’s Manual
A
PPENDIX
> T
RANSFERRING
M
AP
S
OURCE
D
ATA
Transferring MapSource Data
If you have purchased a Garmin MapSource CD-ROM
mapping program, you may want to transfer detailed data
before beginning use to provide your unit with maximum
Find features. The Rino 110 accepts up to 1 MB of map
data from the MapSource Points of Interest. It is not
possible to transfer 3rd party maps into Garmin products.
Map data transfer requires the use of a PC, a Garmin
MapSource CD-ROM, and the PC Interface Cable with
RS-232 serial port connector supplied with this unit.
Follow detailed instructions for data transfer in the
MapSource User’s Manual.
To setup for data transfer:
1. Remove weather cap from the Power/Data Port
on the back of the unit by lifting up on the rubber
weather cap.
2. Connect the serial port connector on the cable to
an available serial port on your computer.
3. Connect the remaining cable connector to the
back of the Rino 110 by orienting the slot on the
connector with the indexing bar on the back of the
unit and push the connector until it is fully seated
in the unit.
4. Turn on the Rino 110 and follow instructions for
map data transfer provided in the MapSource
User’s Manual. See also the “Interface Setup
Page” section for unit interface settings.