Grandstream Networks GXP1400 - Manual (Page 34)

Grandstream Networks, Inc. GXP1400/1405 User Manual Page 33 of 36
Firmware version: 1.0.1.83 Last Updated: 08/2011
No Key Entry Timeout Default is 4 seconds.
Use # as Dial Key This parameter allows users to configure the “#” key as the “Send” (or “Dial”) key. If
set to “Yes”, the “#” key will immediately send the call. In this case, this key is
essentially equivalent to the “(Re)Dial” key. If set to “No”, the “#” key is included as
part of the dial string.
G723 Rate Encoding rate for G723 codec. By default, 6.3kbps rate is set.
G726-32 Packing Mode Select “ITU” or “IETF” for G726-32 packing mode.
ilbc Frame Size ilbc packet frame size. Default is 20ms. For Asterisk PBX, 30ms might be required.
ilbc Payload Type Payload type for Ilbc. Default value is 97. The valid range is between 96 and 127.
Conference URI Configure the conference URI when using Broadsoft N-way calling feature.
Special Feature Default is Standard. Choose the selection to meet special requirements from Soft
Switch vendors.
S AVING THE C ONFIGURATION C HANGES
After the user makes a change to the configuration, press the “Update” button in the Configuration Menu.
The web browser will then display a message window to confirm saved changes.
We recommend rebooting or powering cycle the IP phone after saving changes.
R EBOOTING THE P HONE R EMOTELY
Press the “Reboot” button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.