GE JV624J - Manual (Page 2)

To Operate Motor and Fan
To Clean Motor and Fan
LAMP SWITCH FAN SWITCH
Lamp Switch
For models JV322 and JV332, switch has OFF and ON
positions. For other models, CENTER position OFF,
LEFT position NIGHT LIGHT, RIGHT position
BRIGHT LIGHT.
Fan Switch
CENTER position OFF, LEFT position LOW SPEED,
RIGHT position HIGH SPEED.
To Maintain
Grease Filter
The efficiency of your hood depends on a clean filter.
Frequency of cleaning depends on the type of cooking you
do. BUT GREASE FILTER SHOULD BE CLEANED
AT LEAST ONCE A MONTH. NEVER OPERATE
THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Press outward on spring clip, pull down and
snap out filter.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove imbedded
soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for years. If
replacement becomes necessary, order part number
WB02X2052 from your dealer.
To replace: Put the filter rim in and against two clips,
push outward on the third clip and press filter upward
into place.
Hood
Clean grease laden surfaces of the hood frequently. Use
warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
CAUTION: Be certain when cleaning hood
surfaces you do not touch lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF THE
CIRCUIT BREAKER.
2. Remove filter.
3. Wipe fan blade and motor with cloth, dampened only
in ammonia and warm water solution.
4. Replace filter.
5. Reconnect the hood power supply.
Lamp Replacement
Models JV324J, JV334J,
JV335R, JV624J,
JV634J, JV634R and JV635R
have a lamp cover.
The lamp cover need not be
removed for lamp removal or
installation.
CAUTION: Let lamp cool completely before
removing. A warm or hot bulb may break if touched
with a moist cloth or hand.
Remove lamp and replace with an ordinary screw-base
lamp bulb NOT MORE THAN 60 WATTS.
To remove lamp cover, if desired:
●
Press the sides with two fingers until the side prongs
are released.
. Lift lamp cover and slide towards you in one motion.
To replace lamp cover:
●
Insert prong located at end of cover into top opening.
●
Gently push cover up and press sides to fit side prongs
into the side openings.
●
Release and cover will lock in position.
Requirement
WARNING: THE ELECTRICAL WIRING AND
FAN MOTOR IN THIS RANGE HOOD ARE NOT
INTENDED FOR USE WITH, OR PROVIDED
WITH A SOLID STATE SPEED CONTROL. ANY
SUCH ALTERATION FROM ORIGINAL
FACTORY WIRING CONCEPT COULD RESULT
IN DAMAGE TO THE UNIT AND/OR CREATE
AN ELECTRICAL SAFETY HAZARD.
2