GE DBLR333GT - Manual (Page 11)

About the reversing the door.
Customer Ser
vice
Tr
oubleshooting T
ips
Operating Instr
uctions
Safety Infor
mation
Reversing the Door
Tools needed:
■ Standard #2 ■ Tape-tipped ■ Needle-nosed
Phillips screwdriver putty knife pliers
Open the door and remove the filler plugs opposite
the hinges. With the door completely open, remove
the bottom screw from each hinge on the dryer face.
Insert these screws about half way into the
TOP
holes, for each hinge, on the opposite side (where
you removed the filler plugs). Apply firm pressure
to get the screw started in untapped holes.
Loosen top screw from each hinge on the dryer face
half way. With one hand holding the top of the door
and the other hand holding the bottom, remove the
door from the dryer by lifting it
UP and OUT.
Rotate the door 180°. Insert it on the opposite side
of the opening by moving the door
IN and DOWN
until the top hinge and the bottom hinge are resting
on the top screws inserted in step 1.
Remove the remaining screws from the side of the
opening from which the door was removed. With
these screws secure each hinge at the bottom.
Tighten the two top screws of each hinge. Reinsert
the plastic plugs on the side from which the door
was removed. 4
3
2
1
11