Philips Magnavox ZV427MG9 - Manual (Page 12)

12 EN EN
FUNCTIONAL OVERVIEW
Using a Remote Control
15
19
20
21
24
27
31
1
2
4
6
8
10
9
13
3
25
17
16
1211
14
29
7
22
23
26
28
30
32
18
5
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the remote
control and the infrared sensor window on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote control for different devices can interfere with
each other. Avoid using remote control for other device
located close to the unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote control.
• The maximum operable ranges from the unit are as
follows.
- Line of sight: approx. 23 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx.
10 feet (3m) within 30°
Install the batteries (AA 1.5V × 2) matching the polarity
indicated inside battery compartment of the remote
control.
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Lithium or ni-cad and ni-mh rechargeable batteries
are not recommended to use for remote control.
• Do not mix different types of batteries such as
alkaline and standard (carbon-zinc).
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
• Make sure that the + and - ends of each battery
match the indications in the battery compartment.
• Remove batteries from battery compartment that is
not going to be used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction’s rules that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
16 feet (5m)
30˚
16 feet (5m)
30˚
23 feet (7m)
Remote Control
Installing the Batteries in the Remote Control
1 Open the cover.
2 Insert batteries.
Make sure to match + and - on the batteries to
the marks indicated in the battery compartment.
3 Close the cover.