MITSUBISHI ELECTRIC XD50U - Manual (Page 32)

E-31
ZOOM
CANCEL
ENTER
TIMER
KSTN
VOL
MENU
General Operation
Enlargement of the Image and Video Movement
This function digitally enlarges the personal computer image and video
image (up to 10 times).
(1) Press the ZOOM button.
The zoom selection display will appear.
(4) (3)
(1)
(2)
(2) Enlarge to the desired size.
Each press of the (+) button enlarges the image and each press of the
(–) button makes the image smaller (returning it to 1:1).
(3) Pressing the SELECT
̆̄̇̈ buttons on the remote control at
the time of the zoom operation will cause the display position to
move.
(There will not be any movement when zoom is at 0.)
(4) To close the display immediately, press the CANCEL button.
In the absence of operations for a period of about 10 seconds, the
display will close automatically.
(1) (2) (3)
(No enlargement) (Approximately 2 times enlargement) (Movement)
The image can also be moved in the following circumstances.
• When “Aspect” is set to “Real” by the signal of the personal computer, and the input resolution is
higher than the display resolution of the projector.
• When “Aspect” is set to “Zoom” by the video signal.
Note:
After magnifying the image, be sure to use the ZOOM button to bring the gauge value back to “0”.
Note
* Zoom and image movement functions are cancelled when the input is switched.
* The greater the zoom enlargement, the less distinct the image will appear. The reason for this is that the dots are being digitally corrected
so that they are not conspicuous.
* Movement of the screen will not be possible when the menu screen is being displayed.
Zoom 0
Zoom 0 Zoom 21 Zoom 21