Mamiya C330 - Manual (Page 22)

Mamiya C330S: Page 20
Distance Scale (cont.) 20
Replacing the Distance Scale
To remove the distance scale, first, fully extend
the bellow by turning the focusing knob, then
remove the scale end cover by sliding it to the
front. Next, detach the distance scale from the
bearing, while pressing in the distance scale
shaft with a pointed, fine wire.
When installing the distance scale, insert the
shaft end opposite the revolving knob into the
camera body bearing. Insert the shaft end while
pressing the spring located near the bearing to
the inner side with the side of the scale. Next, fit
the shaft to the front bearing while pushing in the
shaft tip with a finger nail; then install the cover
as it originally was.
<- Prev | Table of Contents | Next ->
file:///E|/c330s/page_20.html [22-10-2003 15:26:37]