Motorola WORDline FLX - Manual (Page 3)

7
Note: If a message is unread, your pager gives a periodic alert until all unread
messages are read. This will continue for up to 30 minutes. A message is
considered read if any part of the message is displayed.
➌ Press º to read the selected message or
press ¡ to select another message, then
press º .
Hint: On this screen, pressing ∞ displays
the previous screen.
➍ If your pager is set to scroll the message
automatically (
SCROLL 1 , SCROLL 2 , or SCROLL 3 ),
the remainder of the message is automatically
displayed at that speed.
Hint: To pause or restart a scrolling
message, press
º .
If the scrolling speed is set to LINE-BY-LINE ,
press º to view the next screen.
➎ Allow the pager to automatically return to the
standby screen, or press
∞ then º .
s 00:0 2 cfwi u qyto
† ¥å¥
s10:35a fwiuqyt o
2:Call Bill 279-1234
time the message
was received
message number
message
continuation
indicator
MESSAGES
8
Scanning Your Messages
When the first line of a message is displayed, press ¡ to scan all messages of the
same type. The message number and the first line of the message are displayed for
each message.
Duplicate Messages
When a duplicate message is received,
DUPLICATE is displayed after the message number
and before the message. The time the duplicate
message was received is displayed.
s10:35a fwiuqyt o
1: DUPLICATE
MESSAGES
9
Setting the Time and Date
Hint: Pressing and holding ∞ scrolls through selections quickly.
➊ From the standby screen, press ∞ to display
CONTROLS? . The controls menu icon w flashes.
➋ Press ¡ to enter the CONTROLS menu.
➌ Press and release ∞ until TIME/DATE? is
displayed.
➍ Press ¡ to enter the TIME/DATE menu. The
hour field flashes.
➎ Press and release ∞ to adjust the hour.
➏ Press ¡ to move to the next field.
➐ Repeat steps 5 and 6 for the minutes, AM/PM,
month, and day fields.
➑ Press º from any field to save.
s 00:00af wie= yto
CONTROLS?
s 00:00af w iuqyto
OFF?
s 00:00af w iuqyto
TIME/DATE?
s 00:00afwiuqyto
12:00 1/01
s 00:00afwi e qyto
12:35P 4/23
TIME/DATE
10
Setting the Incoming Message Alert
You can set your pager to alert with a vibrating alert (vibration with no alert tone), one
of the audio alerts, a chirp alert (short beep alert), an alert of increasing volume
(Escalert), or no alert (completely silent).
➊ From the standby screen, press and release ∞
until ALERTS? is displayed. The alert icon e
flashes.
➋ Press ¡ to enter the ALERTS menu. VIBRATE? is
displayed.
➌ Press and release ∞ until your choice of
VIBRATE? , AUDIO? , CHIRP? , ESCALERT? , or NO ALERT
is displayed.
➍ Press ¡ to select the desired alert. The
standby screen is displayed with the
corresponding alert icon.
s 00:00af wie= yto
ALERTS?
s 00:00afwi u =yto
VIBRATE?
s 00:00afwi - =yto
AUDIO?
s 00:00cfwi e =yto
CHIRP?
ALER
TS