Remotevision 60, Accessing the remotevision control panel 60, Remotevision – Miele KWT1611VI User Manual
Page 60: Remotevision system, Accessing the remotevision control panel
RemoteVision System
The Miele RemoteVision system is
designed to send messages directly to
Miele and/or your PC.
For information on set-up and
installation of the RemoteVision module
see the "Installation" section of this
manual.
Be sure your wireless system meets the
following requirements
– Windows XP
®
or newer operating
system, Mac
®
OS X 10.3 or higher
– Cable or DSL modem
– Microsoft
®
Internet Explorer 6 or
higher, Safari 2.0 or higher, Firefox
1.5 or higher
* Please note that each wireless router
manufacturer supplies their own device
drivers and setup programs. Due to the
differences in manufacturers, exact
router setup instructions are not
included in this manual. Wording and
instructions may vary.
Accessing the RemoteVision
control panel
^ Touch the access button "p" so it
turns yellow.
^ Touch the sensor button for any
temperature zone so it turns yellow.
^ Note the position of the button
X, but
do not touch.
^ Touch the access button "p" again so
it turns white.
Only the access button "
p" is visible.
^ Place one finger on the position of
the
X button and hold (the X button
will not be visible).
^ While holding down the
X button,
press the access button "
p" once.
Keep holding the
X button down until
the following appears in the display
(approx. 5 seconds).
Access to the Custom settings mode is
now active for approximately 10
seconds.
RemoteVision
60