Mercedes-Benz Comand 6515 6786 13 - Manual (Page 152)

152
Navigation
Route guidance
Muting current voice instructions
̈ Press J.
The current announcement is stopped.
You will hear the next navigation
announcement normally.
Switching voice instructions On/Off
Switching off
̈ During a navigation announcement
press
J for 2 seconds.
You will hear a confirmation beep if the
beep tones option was activated in the
system settings (
୴ page 217).
The message Voice Announcements
Muted will appear briefly. Further route
guidance takes place using only the
symbols in the display. If a new route
guidance cycle is started, the
announcements are automatically
switched on again.
Switching on again
̈ Press j.
The navigation displays are only visible
while route guidance is active.
To switch to the navigation display from
another display, e.g. from CD operation:
̈ Press b or c.
Two examples are shown below:
Display example 1:
The road you are currently driving on is
shown on the status bar, in this case
I-90 .
The indication 120 mi is the distance to
the next driving maneuver.
If the GPS position display ( ୴ page 170) is
active, the GPS data are shown instead of
the street name.
Navigation displays
i
Using the multifunction steering wheel
buttons, the display unit can be
changed between km or miles (see
your vehicle’s Operator’s Manual).
ț When the display unit is set to
miles, the COMAND will indicate
distances in miles (mi) or feet (ft).
ț When the display unit is set to km,
the COMAND will indicate
distances in kilometers (km) or
meters (m).