Mercedes-Benz Comand 6515 6786 13 - Manual (Page 182)

182
Navigation
Software Updates
̄
Software Updates
You can update the system with a new
navigation DVD. The new DVD may include
new maps and/or new device software.
Starting an update
̈ Switch the COMAND on ( ୴ page 34).
DVDs are loaded and ejected at the
navigation computer.
Ejecting
̈ Press l.
The navigation computer ejects the
DVD.
Loading
̈ Insert the new navigation DVD into the
DVD slot with the label side up.
The message Navigation Being
Activated Please Wait will
appear.
After that, the COMAND loads the
software on the DVD.
Shortly after that, the progress bar
appears. After some time, the progress
bar reaches 100%.
The update is completed. You can now
operate the navigation system again.
The message Navigation Being
Activated Please Wait appears after
the system is switched on:
ț for a short time
The update is completed. You can now
operate the navigation system again.
ț for a longer time
COMAND was unable to update the
software.
i
Updating may take several minutes.
During updating, the operation of
COMAND is restricted. You cannot
switch off the system.
After updating, the car should remain
outside under open sky for 10 minutes
with the ignition on.
i
The navigation computer is located on
the left side in the trunk (
୴ page 127).
i
If you do not remove the DVD from
the slot within around 15 seconds, the
COMAND will pull the DVD into the
drive.