MITSUBISHI ELECTRIC TG-2000A - Manual (Page 17)

14
6.2 Basic Mouse Operation
First, use of the mouse as a pointing device will be explained. If a device other than a mouse is being
used, consult with the manual for that device.
The following is a list of terms used in describing mouse operations.
Click : This refers to pressing and releasing the button one time.
To use this function, click the button
Double Click: This refers to pressing and releasing the button twice in quick succession.
Drag
: This refers to moving the mouse pointer on top of an object on the screen, pressing
and holding down the button to select the object, then, while holding the button down,
moving the mouse pointer, and the object, to a different location.
Keyboard : Primarily used when entering password, characters, or numerics.
6.3 Accessing Functions and Moving between Windows
The functions of the TG -2000A can be divided into two general categories.
1) Functions that monitor air conditioner operation status and control functions……Initial window
2) Operation and system initialization and charge data maintenance functions (functions used to
accomplish functions in 1) above)……Control window(Management screen)
This section deals mostly with functions in category 2).
(1) Shift from the initial window to the control window
The following shows the procedure to shift from the initial window to the control window. Shift the
screen to the control window after completing the initial setting shown in Chapter 8.
[Procedure]
1) Select [Finish] button.
Click the [Finish] button located on the lower right on
the initial screen. With the above step, the
confirmation screen (asking whether or not to trans-
mit the setting contents to the G-50A) is displayed.
2) Select [OK] button.
Click the [OK] button to transmit the initial setting
contents to the G-50A.
The start-up display screen is displayed after the
screen has been shifted to the control window. The
system information set or changed is transmitted to
each G-50A to enter upon the start-up processing.
It takes approximately
10 to 20 minutes to start-up.
* Note that the setting contents will not be trans-
mitted to the G-50A when the [Cancel] button is
clicked. If it is used when only the maintenance
group function is operated, it is possible to shorten
the time required until the control window
resumes.
(2) Shift from the control window to the initial
window
The control window shifts to the initial window when
the initial setting contents are changed or when the
charge calculation maintenance is performed.
[Procedure]
1) Select [Configuration] and then [System set] in the
menu bar.
Click the [Configuration] in the menu bar on the
control window to select the [System set]. The
password confirmation screen is displayed.
Screen of confirmation for
transmitting set contents
Start-up display screen
Display screen of Shift to setting screen