McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 147)

7
Configuring an E_Port Extension over an ATM WAN 7-9
Configuring a 1x1 ATM Wide Area Network
NOTE: If a bootp message is not received within 45 seconds, you will get the
following Warning message. Use the procedure to manually configure the
Maintenance IP Port. The procedure is found on the UltraNet Edge Storage
Router Technical Documentation Library CD, titled, Manual Configuration of the
Initial IP Settings.
5. Repeat step through step for the second node (Node 20).
6. Continue the configuration process by proceeding to the “Setting
the License Information” procedure.
Setting the License
Information The License Key Wizard determines which features can be enabled
for your network.
1. Right-click on Node10 and select Set License Info from the menu
that appears.
The License Wizard - Introduction dialog box appears.