McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 176)

8
8-4 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
Figure 8-2 UltraNet ConfigManager Main Window
Adding Nodes for
an Ethernet WAN
Configuration Use the following procedures to create a network map for a 1x1
Gigabit Ethernet WAN configuration. This configuration will have
two nodes that extend one Fibre Channel interface over one Gigabit
Ethernet WAN.
NOTE: If you are configuring a 2x2, the Ethernet Maintenance Interface and
both WAN interfaces must be on separate subnets.
1. Select the Nodes tab located on the toolbar between the TreeView
Area and the Network Map Area.
The Nodes tab displays three drop-down menus, containing the
node types for each available UltraNet Edge Series.
Tree
View
Area
Network
Map
Area