McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 184)

8
8-12 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
5. Right-click on Node 20 and then repeat step through step to set
the licensing information for this node.
6. Continue the configuration process by proceeding to the “Adding
an IP Circuit” procedure.
Adding an IP Circuit You will now create an IP circuit. A circuit is the IP WAN link
between Node10 and Node20. Use the IP Circuit Wizard to create and
configure the IP circuit by using the following procedure:
1. Select the Links tab on the center toolbar.
2. Click the IP icon on the center toolbar.
3. Click the first node to create an IP circuit (in this example,
Node10).
This will cause “marching ants” to highlight the area around the
node icon, indicating that the node is in a special configuration
mode.
4. Click the second node (the destination that you want to connect
the circuit to).
The IP Circuit Wizard Introduction dialog box appears.
IP icon (globe)
Links tab