McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 210)

9
9-2 McDATA UltraNet Edge 3000 User Guide
Network Configuration Examples
Network Configuration Examples
The following illustrations are examples of FC/SCSI Tape Pipelining
(Device Extension) network configurations. Depending upon what
your network configuration consists of, each configuration has
different requirements for Fibre Channel switch zoning, static Edge
LUN mapping, and source WWN filtering. Each illustration below
shows the associated parameters for Fibre Channel switch zoning,
static Edge LUN mapping, and source WWN filtering for its specific
example.
It may be helpful to read through the “Dynamic Target LUN
Discovery and LUN Mapping” section in Chapter 10 for an
understanding of the Edge’s functionality before attempting to
configure your network.
Example of
Uni-directional
Configuration - No
Zoning Figure 8-1 provides an example of a simple uni-directional
configuration using FC/SCSI Tape Pipelining. Fibre Channel switch
zoning and static Edge LUN mapping are not required for this
configuration.
Figure 9-1 Uni-directional FC/SCSI Tape Pipelining - No Zoning
In the configuration above (Figure 8-1), Edge node 10 automatically
maps all of the devices attached to Edge node 20, into its LUN map.
Server A is now able to access those devices through Edge node 10’s
LUN map.
Sb042
UltraNet Edge
Storage Router
Node 10
UltraNet Edge
Storage Router
Node 20
Fibre Channel
Switch 2
Media
Change 2 r
Tape
Drives
Tape A1
Tape A2
Tape A3
Server A
Tape A4