McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 290)

12
12-12 McDATA UltraNet Edge 3000 User Guide
10/100 Ethernet Interface Card Installation Procedure
6. Carefully pull the 10/100 Ethernet interface card up. The 10/100
Ethernet interface card is connected to two socketed connectors.
7. Remove the 10/100 Ethernet interface card from the chassis.
8. Follow the 10/100 Ethernet Interface Card Installation Procedure
to install the new 10/100 Ethernet interface card.
10/100 Ethernet Interface Card Installation Procedure
Use the following procedure to install the 10/100 Ethernet interface
card into the UltraNet Edge 3000 chassis.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15 in-lbs.
CAUTION
Make sure the power is off. Attach a wrist strap and follow ESD
procedures (see page B-19) during the handling of all electronic
components.
1. Carefully insert the 10/100 Ethernet interface card in either I/O 3
or I/O 4.
For I/O 3, the 10/100 Ethernet interface card will plug into
location J8 and J9 on the motherboard. If the 10/100 Ethernet
interface card is being installed into I/O 4, plug it into location J10
and J11 on the motherboard.
Sb1
1
8
10/100 Ethernet
Interface Card
Screw (2)
I/O 4
I/O 2
I/O 1
I/O 3